DIY – Terracotta Bud Vases

Robert Anderson from Curtain Clean Levin

Take on the terracotta trend and sculpt a unique floral feature.

You will need:

- Modelling clay (air-drying or baking)
- Rolling pin

- Knife
- Straw
- Fine sandpaper
- Test pot brush
- Paint test pots (we like Resene Sakura & Resene Apple Blossom)
- Resene FX Paint Effects Medium
- Small sponge
- Cord to hang

Step one: Start by rolling out your clay about 7mm thick (A). It’s important to work on a clean, non-stick surface.
Step two: Use a knife to cut a rectangle as long as you want the main shape to be, then cut a square roughly twice the width of the rectangle and two-thirds the height (B). No matter what shape you’re making, the top piece must be wider to form a dome or pocket. The backing piece always needs to be taller and have enough height to support your flora and allow for a hole.

Step three: If using air-drying clay, dip your fingers in water and wet the edges of the clay slightly – baking clay does not require any water to seal together. Take the smaller, wider square piece and make an arc over the backing piece, bringing the sides together (C). Press the sides down so the clay bonds together, then do the same along the bottom (D), making sure you still have a curved opening at the top.

Keep reading: www.curtainclean.co.nz...

More messages from your neighbours

1 day ago

Driven On The Akatarawa Rd Lately?

Marie from Waikanae

If so, its good to know you are still alive and reading this.

We have a function to go to over Christmas up that way and having heard a few hairy stories about the road, I went up there on Thursday to check it out. The road's ok, narrow and winding, but not much worse than a Wellington hill suburb. What was pretty scary was the behavior of other drivers. Three vehicles heading the other way at speed would have crashed into me if I hadn't been pulled off the road. I had pulled in to check the address when a truck came flying past, taking up all of the narrow road at speed. There is no way the driver would have been able to stop had they come around the corner immediately in front of me. The other two drivers came hurtling past as I had turned in to turn around and come back down the hill. They were also driving at speed and taking up most of the road. Coming back down I passed another car coming up and estimate that the safe speed to pass another car was about 30-35 kms.p.h. So, now we're thinking, do we go to the function or not.? Feels a bit like we're taking our life in our hands going up there. Drivers appear to be overconfident, and they are courting serious injury.